M100-T in a Metering System
Thanks to the standard casing, the M100-T Modem can be mounted to new or already installed metering devices. The M100-T Modem functions as a link between the metering device and system. Using appropriate reading software the metering information can be read from the metering device via the M100-T Modem. The M100-T Modem can also be used with metering devices that have originally been planned for local serial communications only. This is possible as the M100-T does not require extra handshaking signals or commands from the metering device. The M100-T Modem can be used with either heat or electricity meters. Thus it allows the integration of heat and electricity metering into one metering system.
The M100-T Modem supports data communication with speeds from 300 up to 33600 bits/second in telephone networks or with leased lines. Therefore the company can make use of its own signal cable network. The M100-T Modem has a standard RS-232 interface, and also two-wire current loop signalling for up to three metering devices (CS-interface), extending the communication range also to CS-meters. The communication interface type can be changed on the field simply using a switch PSTN MODEM
The M100-T Modem is compliant with the European CTR-21 requirements and naturally it fulfils the standard European requirements regarding electrical safety and electromagnetic interference.
The A-subsciber identification makes it possible to use public telephone lines without disturbing the end-user. It is possible to configure up to 52 telephone numbers into the modem’s memory. After that it accepts only calls coming from these numbers. Thanks to the A-subscriber identification, the modem is protected from unauthorised use and configuration. A-subscriber identification for the M100-T Modem is available in Finland, Denmark, Norway, Sweden and the Netherlands.
The M100-T Modem has a call-back function which helps to protect the device from answering any illegal calls. Thanks to caller identification, the M100-T Modem can be configured to accept calls from specified numbers only. As a further safety measure, the M100-T Modem can be configured not to answer the call even if it accepts the number, but to call back after a while. This way the modem ensures that the call is from a correct number. The M100-T Modem can be configured so that the device it is connected to decides if an incoming call is answered. Both of these features together with the caller identification increase the modem’s security in use.
With the M100-T Modem Landis+Gyr offers a comprehensive communications solution for the overall metering system. The M100-T Modem is compatible for example with the following items of the Landis+Gyr product range: MC110 concentrators, E700 industry meters, MT33r terminal units as well as the 9EVL, 10EVL and 11EVL heat meters. Regarding compatibility with other metering devices, please contact Enermet.
The M100-T Modem is easy to install to the terminal block of electronic DIN or ERMI metering devices, or directly to a wall. The M100-T Modem does not need an external power supply and it can even supply the single phase 230 V e.g. for a heat meter. Wiring can be carried out using slotheaded screws without any special tools.
- Simple way to connect existing measurement devices to system like district heating meters
- Modem utilises the existing communications infrastructure: no extra wiring is needed
- 12KV Mains 230V and 10KV PSTN
- Tamper proof
- Easy installation
- Support for current loop signalling up to 3 meters
M100T GB Fact Sheet
- PSTN (Public Switched Telephone Network) communication